Rolex Daytona Strap Adjustment Length
watch exploreConsidered the first to bring the way to disassemble a retractable watch band. The first step is to measure the strap by looping the retractable watch at the wrist and see how many sections overlap. Based on this, add a section to get the number of watch band sections we want to remove. In reality, these watch straps are relatively simple to disassemble.Article from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-html
Then open the cover on the edge of the watch face. Place the strap upside down on the table, then locate the part to be removed and pull back the edge of the strap.Article from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-html
Then open the bottom edge cover. Turn the strap over and similarly open the layer covering the edge of the strap. When you open the surface edge cover, you will naturally see the bottom cover.Article from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-html
To remove the unwanted stage of the watch belt, gently roll the watch belt knuckle outwards, so that the part we want to remove can be easily separated.
Summary:Article from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-html
1. first brought the way to disassemble the retractable watch band. The first step is to measure the strap by looping the retractable watch at the wrist and see how many sections overlap. To this, add a section to get the number of watch band sections we want to remove. In reality, these watch straps are relatively simple to disassemble. Then remove the cover on the edge of the watch face. Turn the watch band over on a tabletop, find the section to be disassembled, and detach the watch band face edge.Article from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-html
2. Then open the cover on the bottom edge. Flip the side of the strap and also open the layer covered by the edge of the strap. When you open the cover on the surface edge, you will naturally see the bottom cover. Remove the excess strap links and gently slide the strap knuckles so that the parts you want to remove can be easily separated.Article from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-htmlArticle from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-html
How to adjust the Rolex Daytona clasp
Article from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-html
The top of the Rolex watch bracelet with the logo where the trademark logo is located is a folding clasp that can be pulled outward using a fingernail.Article from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-html
Specific Steps:Article from watchdetective replica - https://www.bbtwatch.com/en/wbzs/76746-html
1. Place the watch at your wrist, look for where the clasp is located, and place your fingertips (middle finger, so to speak, or any other finger, the key is personal preference) on either side of the clasp;
2. Finger into the watch strap and folding buckle right in the middle, with the thumb of the finger pressure on the other side of the watch strap, played a fixed immobilization of the other side of the watch strap effect, to avoid pulling the folding buckle;
3. Reach to the watch strap and folding buckle between each other's arm a little hard, positive upward pull watch strap, can also be successfully completed very well to enable the Rolex watch folding buckle. But be careful, don't use your fingers can directly fasten the folding buckle above the Rolex watch logo to enable the folding buckle.
